Homing Y-Axis at the Back, but Home Position at the Front - Page 2 - Centroid Community CNC Support Forum

Homing Y-Axis at the Back, but Home Position at the Front

Moderator: cnckeith

12 posts

ShawnM: Community Expert; Posts: 2923; Joined: Fri May 24, 2019 8:34 am; Acorn CNC Controller: Yes; Allin1DC CNC Controller: No; Oak CNC controller: No; CNC Control System Serial Number: 7804734C6498-0401191832; DC3IOB: No; CNC12: Yes; CNC11: No; CPU10 or CPU7: No; Location: Clearwater, FL

Re: Homing Y-Axis at the Back, but Home Position at the Front

Quote

Post by ShawnM » Wed Apr 09, 2025 10:54 am

suntravel wrote: ↑Wed Apr 09, 2025 8:16 am
ShawnM wrote: ↑Wed Apr 09, 2025 7:55 am ..... Gary Campbell tells me all about his Shopbot days, I can't help but bang my head against my keyboard sometimes.
not the best idea if ENTER = Cycle Start

Uwe

OMG, that's why it started the job.

Thanks for the laugh Uwe.

(Note: Liking will "up vote" a post in the search results helping others find good information faster)

suntravel: Community Expert; Posts: 3446; Joined: Thu Sep 23, 2021 3:49 pm; Acorn CNC Controller: Yes; Allin1DC CNC Controller: No; Oak CNC controller: No; CNC Control System Serial Number: 6433DB0446C1-08115074; DC3IOB: No; CNC12: Yes; CNC11: No; CPU10 or CPU7: No; Location: Germany

Re: Homing Y-Axis at the Back, but Home Position at the Front

Quote

Post by suntravel » Wed Apr 09, 2025 11:32 am

That is called a head start

(Note: Liking will "up vote" a post in the search results helping others find good information faster)

Post Reply

12 posts

Return to “Centroid Acorn CNC Controller”