Page 2 of 2
Re: Using Lightburn and rotary
Posted: Sun Mar 30, 2025 7:04 pm
by grossmsj
I used G37 ON (velocity based PWM on).
Did not enable G93 (inverse time mode).
Re: Using Lightburn and rotary
Posted: Mon Mar 31, 2025 2:26 pm
by kman1967
Was using G37. I'll have to check the G93
Re: Using Lightburn and rotary
Posted: Mon Mar 31, 2025 7:14 pm
by grossmsj
Your other question about adjusting velocity modulation is very interesting. I know nothing about how that works, but it's an interesting question as to how it might be 'off' (if that is even a thing here). It made me wonder whether certain smoothing settings might affect motion in a way not anticipated by the PP. It certainly is an issue with the delay caused by RAS with Clearpath servos. When I did the rotary laser engraving I had all smoothing switched off.