Ohmic touch off not responding

[_Duke_]

I've just updated to v5.2, I input all my old values from the previous install.
Now whenever I go to probe the z with the ohmic torch tip, it keeps going and crashes and trips the breakaway.
On the Alt+i diagnostic screen, the #9 input works as it should when I ground out the tip.
Is there some new setting I have to change in 5.2?

[Joey]

Is the THC set to Installed in the Profile manager's THC Config settings?

[_Duke_]

Ooh good call, I did forget to enable that!
But unfortunately that didn't fix the issue

[Joey]

Hmmm ... Did you hit "done" at the bottom THC Config menu?

That should of been the trick.

The Input state is not forced in the alt-i screen correct?

[_Duke_]

Wow, that was super weird.
It definitely saved the settings in the THC menu.
I opened up the alt+i menu once more, forced it with ctrl+alt+i, tried again- same result. Then I hit ctrl+alt+i to unforce it again, and now it's working. Joey you're a genius!