CNC12 Router v5.20 is now available

[tuffduck]

I noticed the incremental movement for each axis has been either moved or removed. What is the recommended work around?
Thanks

[ShawnM]

Sure, no deal to make it work, but even Intercon on a router is posting M7 if Mist is selected in the tool lib.

This one shortcut misusing M7 for Dust has a long rattail now.

If it is changed correctly to maybe M107, lots of users will curse Centroid because they have to change something

IMHO the best bet is to stay with ISO 6983 for all basic functions.

Uwe

I'll admit I've never used Intercon and have no need to or plans to so maybe I'm not the best person to comment then.

[tuffduck]

Trying to find this screen.
Thanks

[tblough]

Chapter 6.6 in the manual

[tuffduck]

Thanks

[cncsnw]

F1/Setup -> F4/Feed -> F2/Inc

[cnckeith]

I noticed the incremental movement for each axis has been either moved or removed. What is the recommended work around?
Thanks

- most use MDI to do this.

- the menu's have been moved
F7 Utility, ---> F4 Power Feed

- we are working on a CNC12 Router Operator manual.

[Boatwrights Workshop]

Will there be a revised manual for the new features, especially for the "Configuration Wizard? I would like to a brief explanation of how to configure these screenshots I have posted? I have tried the "Touch Plate" configuration but I get a notice saying it's not setup correctly even though my tool touch off is functionable in Input #7.

[cnckeith]

Will there be a revised manual for the new features, especially for the "Configuration Wizard? I would like to a brief explanation of how to configure these screenshots I have posted? I have tried the "Touch Plate" configuration but I get a notice saying it's not setup correctly even though my tool touch off is functionable in Input #7.

yes we are working on a CNC12 Router Operator manual.

for now just post your question on the forum and we'll do our best to answer it.
and you'll have to post a fresh report.zip so we can see your setup. thanks!

[cnckeith]

Will there be a revised manual for the new features, especially for the "Configuration Wizard? I would like to a brief explanation of how to configure these screenshots I have posted? I have tried the "Touch Plate" configuration but I get a notice saying it's not setup correctly even though my tool touch off is functionable in Input #7.

are you confusing a Tool Touch off (aka TT used for setting tool lengths) with a Surface plate typically used to set part zero?