I am doing a rebuild of the cabinet with the ClearPath servs. My current problem is the homing program stops prematurely. It goes to line 11 "G90: absolute position". and simply stops. There are no error messages anywhere. The configuration is set to use the "home to limit switch" I can jog the motor, but it seems the initial position has become the max travel in the direction of the switches. The first line of the program display reads PATH=C\intercom\temp1.INC"
Without an error message I am a bit puzzled what to try next. Any Ieads??
Thanks
homing program stop prematurely
Moderator: cnckeith
-
curiousMike
- Posts: 75
- Joined: Tue Sep 24, 2019 3:05 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
homing program stop prematurely
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
suntravel
- Community Expert
- Posts: 3643
- Joined: Thu Sep 23, 2021 3:49 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 6433DB0446C1-08115074
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Germany
Re: homing program stop prematurely
Yes, post a report...
Uwe
Uwe
(Note: Liking will "up vote" a post in the search results helping others find good information faster)