[Video] How to make CNC12 require two cycle start presses before you get automatic motion.

Moderator: cnckeith

Post Reply
cnckeith
Site Admin
Posts: 9047
Joined: Wed Mar 03, 2010 4:23 pm
Acorn CNC Controller: Yes
Plasma CNC Controller: No
AcornSix CNC Controller: No
Allin1DC CNC Controller: Yes
Hickory CNC Controller: No
Oak CNC controller: Yes
CNC Control System Serial Number: none
DC3IOB: Yes
CNC11: Yes
CPU10 or CPU7: Yes
Contact:
Contact cnckeith

How to make CNC12 require two cycle start presses before you get automatic motion.

Post by cnckeith »

How to make CNC12 require two cycle start presses before you get automatic motion.
F1 setup, F3 Config, F1 Control, "Jog panel required" set to "Yes" press F10.

now, cycle start once loads the Gcode..no motion... cycle another time..now you get automatic motion.

Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63

Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html

Top
Post Reply

Return to “Acorn CNC Tech Tips Knowledge Base, Look Here! before posting”