Dxf

[suntravel]

That is because the conture is not closed, not all points are connected.

Uwe

[Filardo]

That is because the conture is not closed, not all points are connected.

Uwe

however if I look with Qcad no problem and when I select the contour on intercom too

[Filardo]

That is because the conture is not closed, not all points are connected.

Uwe

can you try with these new elements?

[Filardo]

I succeeded with the cnc12 v5.1 Offline Mill and mill Intercon except that my parameters were in inches once I changed to millimeters it no longer works



j'ai réussi avec le cnc12 v5.1 Offline Mill and mill Intercon sauf que mes paramètres était en pouce une fois passer en millimètre ca ne fonctionne plus

[Filardo]

normally a dxf option is made to save time I use it every day when I work on itnc 530 never have so many problems

[suntravel]

I have no problems with dxf import, but this one is also not a closed contour.

To mill pockets, dxf must be closed around the pocket.

I use AutoCAD LT or Inkscape with no problems.

Uwe

[Filardo]

I have no problems with dxf import, but this one is also not a closed contour.

To mill pockets, dxf must be closed around the pocket.

I use AutoCAD LT or Inkscape with no problems.

Uwe

I redid my dxf the outline it selects in one go without problem but it does not want to be interior
I just want to know how to do it with the dxf
here is attached my dxf in outline close can you try

j'ai refait mon dxf le contour ce sélectionne en une fois sans problème mais il ne veut pas faire intérieure
je veut juste savoir comment faire avec le dxf

voici en pièce jointe mon dxf en contour fermer pouvez vous essayer

[Filardo]

I have no problems with dxf import, but this one is also not a closed contour.

To mill pockets, dxf must be closed around the pocket.

I use AutoCAD LT or Inkscape with no problems.

Uwe

this is what I want to create with the dxf

voila ce que je veut créer avec le dxf

[suntravel]

Why do you want to import dxf if you have the model in fusion?

Postprocessor for Centroid in fusion is very good.

Uwe

[Filardo]

Why do you want to import dxf if you have the model in fusion?

Postprocessor for Centroid in fusion is very good.

Uwe

Mon but est d'utiliser un maximum intercom
C'est tellement simple d'utilisation
Imaginons que ma poche est trop petite
En deux temps trois mouvements j'ai modifié mes cotations
Et si j'ai pris cette carte cnc c'était pour option dxf
Je voudrais tellement que cela fonctionne
Pouvez vous regarder le fichier que je viens de poster ce matin
Je comprends pas où est erreur