DB25 or Headers? for drive connections...
Moderator: cnckeith
-
Terry1956
- Posts: 31
- Joined: Thu Jan 11, 2024 6:48 am
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: Yes
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: DB25 or Headers? for drive connections...
Hi out there, I am a bit confused (easy done). I understand that I need to use a db25 board if I wish to use 5v stepper motor drivers. But how do I know which terminal does what. Can anyone please let me know. Thanks.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
ShawnM
- Posts: 2656
- Joined: Fri May 24, 2019 8:34 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 7804734C6498-0401191832
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Clearwater, FL
Re: DB25 or Headers? for drive connections...
The DB25 pin out is on every wiring diagram for the Acorn. It's just to the right of the DB connector on the diagrams in a box labeled H6.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)