Set Acorn to not ask me to switch tool. Chucker mode.

ChrisMe · Post by **ChrisMe** » Tue May 16, 2023 9:55 am

I'm using my lathe in chucker mode so how do I set acorn to not ask me to change tool but to just go from toll 1 to tool 2 to tool 3 automatically?

suntravel · Post by **suntravel** » Tue May 16, 2023 10:02 am

Set parameter 6 to 1, this enables auto tool change.

Uwe

ChrisMe · Post by **ChrisMe** » Tue May 16, 2023 10:18 am

suntravel wrote: ↑Tue May 16, 2023 10:02 am Set parameter 6 to 1, this enables auto tool change.

Uwe

Thank you. Where do I find the parameter menu?

suntravel · Post by **suntravel** » Tue May 16, 2023 10:23 am

pls read the manual....

Uwe

Centroid Community CNC Support Forum