Hi. I'm having trouble with the manual jog functions
- I am using 2 HBS86 closed loop drivers on nema 34 closed loop motor for x and y axis and they both work fine.
-I am using a DM542A driver on nema23 open loop motor for my Z axis. Z+ works fine;
-Z- will stop working whenever I use a X- or Y- command before trying to go Z-.
-Z- will then work again as long as I go back and hit the X+ or Y+ manual jog buttons.
I am using the db25 to drive all axis. I did swap Z and Y axis control and the problem followed the changes. Am I allowed to use two different drives?
Any help would be greatly appreciated
-DCAV
Manual Jog Function in Acorn cnc
Moderator: cnckeith
-
- Posts: 7348
- Joined: Wed Mar 03, 2010 4:23 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Contact:
Re: Manual Jog Function in Acorn cnc
share how you have them wired. are you using drive enable signals? and how are you using them etc.. and post a fresh report.zip so we can see your settings.
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html