The slaved Axis keep getting unpaired.
I have slaved Axis 4 to Axis 2 in the Wizard.
I can confirm in the VCP, and I also verify that both motors are moving as expected.
Then, if I click "Set WCS XY0", the axis are unpaired.
No matter how many times I click on "Re-pair Axes", it is not able to. Even if the message says succesful.
And back in the wizard, sure enough, the axis are still unpaired.
Acorn also shows the slaved axis is no longer enabled.
The motors are Clearpath motors, powered by an IPC5, via the POWER4HUB board.
The motor signals are wired through a https://www.cnc4pc.com/c86accp-clearpa ... oller.html board
I have X on 1, Yleft on 2, Z on 3, and Yright on 4.
I dont understand why it keeps losing axis pairing - is there something obvious I'm doing wrong?
See attached report files
Slave axis getting unpaired <install pro license file>
Moderator: cnckeith
-
- Posts: 25
- Joined: Wed Jan 26, 2022 4:53 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: Yes
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Slave axis getting unpaired <install pro license file>
Last edited by johannes on Fri Sep 16, 2022 11:33 am, edited 1 time in total.
-
- Posts: 667
- Joined: Fri Nov 30, 2018 1:04 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Thorp WI
Re: Slave axis getting unpaired
Do you have a CNC12 Pro license applied? A pro license is required for paired axis configurations.
Scott
-
- Posts: 667
- Joined: Fri Nov 30, 2018 1:04 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Thorp WI