y axis exceeded message
Moderator: cnckeith
-
Black Forest
- Posts: 431
- Joined: Thu Nov 23, 2017 1:39 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Germany
Re: y axis exceeded message
If you are getting the 500mm part from the dimensioned drawing I posted that is not the correct drawing. Sorry about that.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
suntravel
- Community Expert
- Posts: 3778
- Joined: Thu Sep 23, 2021 3:49 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 6433DB0446C1-08115074
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Germany
Re: y axis exceeded message
490mm and 8mm Mill will go with good positioning.
Often by modifying hard stops and home sensor, you can find a couple of extra mm travel...
Uwe
Often by modifying hard stops and home sensor, you can find a couple of extra mm travel...
Uwe
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
Black Forest
- Posts: 431
- Joined: Thu Nov 23, 2017 1:39 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Germany
Re: y axis exceeded message
I can shorten the part another 10mm with no problems I think. I will have a go at it tomorrow.
Uwe check your email. I will send you something.
Uwe check your email. I will send you something.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
Black Forest
- Posts: 431
- Joined: Thu Nov 23, 2017 1:39 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Germany
Re: y axis exceeded message
I was able to adjust things on my table to gain 12.5mm of travel in the X axis. The part cuts now with no problem. Thank you for the help.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)