Hi All,
I upgraded to an All-in-One setup a couple of years ago. All has been fine since until today. When I power on, I don't hear the "pop" when the contactors close, and then I get a "Full power but no movement on Z-axis" error during initial homing.
I don't even know where to begin looking. Any help appreciated!
Mill down: all in one, Lagun with Elrod conversion <fuse, user resolved>
Moderator: cnckeith
-
- Posts: 2
- Joined: Wed May 27, 2020 9:53 am
- Acorn CNC Controller: No
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: 4108
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Mill down: all in one, Lagun with Elrod conversion
Never mind, just a fuse in the contactor circuit. Luckily I had a spare on hand.