I appreciate your input and info on the existing control. I gained tremendous confidence in my ability to do this when I converted an old Sharnoa controller to Centorid with the enormous help from this board.RTech wrote: ↑Wed Dec 29, 2021 4:50 pm I put an Oak in a similar machine a few years ago. Mine also has the Yaskawa drives and I used an OAK board and pre-made drive cables from Centroid for simplicity.
I can't help you with the contactor (I believe I rewired the spindle per the OAK drawings), but the spindle drive works fine with the OAK.
Also, I just wanted to say the CNC-DX32 control and parts are worth a lot to some people. I got enough for the parts on ebay to more than pay for the OAK board!
I really tried to find a good home for the old Sharnoa controller as I had two pick up truck loads of spare parts, boards, etc and at one point I was the guy searching for these spare parts. Sadly, they wound up at a recycling center. I was happy to get the garage space back.
Mark