I am not seeing the menu to change the jog speeds when a probe is plugged in.
Manual says I need "Proper PLC support" but what specifically does that require?
Parameter 153 is set to 1.000 //Probe Protection feature enabled
Any help is appreciated.
Thanks.
Probe Jog Parameters
Moderator: cnckeith
-
- Posts: 7525
- Joined: Wed Mar 03, 2010 4:23 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Contact:
Re: Probe Jog Parameters
Use the Acorn Wizard to set the fast and slow probing rates, refer to the Probe setup guide here.
https://www.centroidcnc.com/centroid_di ... _setup.pdf
https://www.centroidcnc.com/centroid_di ... _setup.pdf
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
-
- Posts: 3
- Joined: Wed Dec 02, 2020 11:42 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Probe Jog Parameters
These setting do not affect the Jog speed when probe is plugged in.
I want to limit the MPG JOG speed when probe is plugged in..
Thanks.
I want to limit the MPG JOG speed when probe is plugged in..
Thanks.
-
- Posts: 7525
- Joined: Wed Mar 03, 2010 4:23 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Contact:
Re: Probe Jog Parameters
would take custom PLC program to do that. I suggest getting in the habit of using the Slow Jog mode in conjunction with the feedrate overide and x1 and x10 incremental when using incremental jogging.
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html