Gremlins

[Gmachine]

Sorry for the delay. Here is a resent video on YouTube with the issues. Now it is in the x and y axis. The only way I can describe the problem is that it is losing steps. The problem is coming and going in all the drives and showed up right after I updated the software to CNC12 v4.64.


I also attached all the reports I did that correspond to the video time stamps to this post.

Any help would be greatly appreciated.

Have a good Memorial day.

[martyscncgarage]

No need to post all the reports. Only a fresh one and maybe one from the previous version.
Did you do a FRESH install and hand copy in all your machine settings or did you restore from an older report?

[Gmachine]

After not finding anything wrong with my connections or wiring I moved forward with wiping cnc 12 and starting over with fresh install. Immediately after the installation and rehoming the machine I could tell it was working properly. I ran my machine for 4 hours on 6/19/21 with not problems. My guess is that a file was corrupted during installation causing my issues. In the future if someone has issues after an update. Tell them to reinstall the software before jumping to conclusions.

[martyscncgarage]

After not finding anything wrong with my connections or wiring I moved forward with wiping cnc 12 and starting over with fresh install. Immediately after the installation and rehoming the machine I could tell it was working properly. I ran my machine for 4 hours on 6/19/21 with not problems. My guess is that a file was corrupted during installation causing my issues. In the future if someone has issues after an update. Tell them to reinstall the software before jumping to conclusions.

I recommend starting with a fresh cleaning install, using Wizard screen shots from the last installation. NOT using Restore Report from an older version if you are having trouble.

I hope your fresh install has helped