I don't see any sign of damage in report.
Get help with machine troubleshooting
Moderator: cnckeith
-
- Posts: 98
- Joined: Fri Jun 10, 2011 8:31 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
Re: Get help with machine troubleshooting
Its a break motor thoroughly check x brake is release or not .
-
- Posts: 11
- Joined: Mon May 17, 2021 10:42 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC12: No
- CNC11: Yes
- CPU10 or CPU7: Yes
Re: Get help with machine troubleshooting
I took the brakes off, mate!
-
- Posts: 376
- Joined: Fri Jan 10, 2014 11:29 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Location: Howard, PA
Re: Get help with machine troubleshooting
Did you try what I posted earlier... like this part:
The HSC screen shows a list of drive status bits. LineVoltageOn should be 1 when the estop is released.
The report looks like you have no voltage.
The HSC screen shows a list of drive status bits. LineVoltageOn should be 1 when the estop is released.
The report looks like you have no voltage.
-
- Posts: 11
- Joined: Mon May 17, 2021 10:42 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC12: No
- CNC11: Yes
- CPU10 or CPU7: Yes
Re: Get help with machine troubleshooting
Can you walk me through the test steps with pictures or videos? Thank you!
-
- Posts: 376
- Joined: Fri Jan 10, 2014 11:29 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Location: Howard, PA
Re: Get help with machine troubleshooting
I don't have that kind of control system set up to demonstrate it right now.
The keys to get from the main screen to HSC are: <F7 - Utility>, <F9 - Logs>, <F5 - HSC> .
LineVoltageOn value for each drive should change within a few seconds of changing Estop state.
The keys to get from the main screen to HSC are: <F7 - Utility>, <F9 - Logs>, <F5 - HSC> .
LineVoltageOn value for each drive should change within a few seconds of changing Estop state.