Anyone know how to get the Tool Trail to display in a 2 axis configuration?
This is on a waterjet
Tool Trail not showing
Thanks
Tool Trail
Moderator: cnckeith
-
- Posts: 3101
- Joined: Tue Mar 22, 2016 10:03 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 100505
100327
102696
103432
7804732B977B-0624192192 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Boston, MA
- Contact:
Re: Tool Trail
You need to specify a tool diameter.
Cheers,
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
-
- Posts: 9914
- Joined: Tue Mar 28, 2017 12:01 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Location: Mesa, AZ
Re: Tool Trail
As Tom mentioned, you need to setup Tool 1 in the Tool Library and give it a diameter. Perhaps the diameter of the water jet stream
F1 Setup
F2 Tool
F1 Offset Library
F2 Tool Library
Read up in the Mill Operator's Manual:
https://www.centroidcnc.com/centroid_di ... -v4.14.pdf
F1 Setup
F2 Tool
F1 Offset Library
F2 Tool Library
Read up in the Mill Operator's Manual:
https://www.centroidcnc.com/centroid_di ... -v4.14.pdf
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ
We can't "SEE" what you see...
Mesa, AZ