This video shown the cutter relative to the table as it first goes to the Park position. Then I simulate power down and restart. The program then does a Home. The camera is position as if you were lying on the mill table looking up at the cutter. Don’t try this at home…
Rick
A video of the Park and Home Functions
Moderator: cnckeith
-
RGSparber
- Posts: 150
- Joined: Sat May 27, 2017 2:12 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 38D269533454-0111180523
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Phoenix, AZ
- Contact:
A video of the Park and Home Functions
(Note: Liking will "up vote" a post in the search results helping others find good information faster)