Thanks to a lot of help from this forum, I was able to make my first cut using Centroid Acorn on my 4 axis RF-30 Mill/Drill:
https://youtu.be/gAalEkMSsoY
Thanks to all,
Rick
My first cut
Moderator: cnckeith
-
- Posts: 150
- Joined: Sat May 27, 2017 2:12 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 38D269533454-0111180523
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Phoenix, AZ
- Contact:
My first cut
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
- Community Expert
- Posts: 9953
- Joined: Tue Mar 28, 2017 12:01 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Location: Mesa, AZ
Re: My first cut
That's awesome Rick! Using Acorn full tilt, all 4 axis. Right on:!:
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ
We can't "SEE" what you see...
Mesa, AZ
(Note: Liking will "up vote" a post in the search results helping others find good information faster)