KP-3 Probe

All things related to the Centroid Acorn CNC Controller

Moderator: cnckeith

Post Reply
n2xd
Posts: 18
Joined: Sat May 26, 2018 8:01 am
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC11: No
CPU10 or CPU7: No
CNC Control System Serial Number: 0943
Location: Franklin,NC

KP-3 Probe

Post by n2xd »

I ordered and received a KP-3 probe this past week. I haven't installed yet. I downloaded the latest wiring drawings that are fresh today 11-21 and same probe with the same part number has 4 wires. The probe that i received has 3 wires. Help the poor boy out please. Thanks.


John
swissi
Posts: 362
Joined: Wed Aug 29, 2018 11:15 am
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
MPU11 & GPIO4D -w/ 3rd Party Drives: No
DC3IOB: No
CNC11: No
CPU10 or CPU7: No
CNC Control System Serial Number: 985DADEB24D5-0309180716

Re: KP-3 Probe

Post by swissi »

n2xd wrote: Sat Nov 21, 2020 5:48 pm I ordered and received a KP-3 probe this past week. I haven't installed yet. I downloaded the latest wiring drawings that are fresh today 11-21 and same probe with the same part number has 4 wires. The probe that i received has 3 wires. Help the poor boy out please. Thanks.
Not sure what you downloaded but this schematics here shows 3 wires:

KP-3_ Acorn.pdf
(184.22 KiB) Downloaded 6 times

-swissi
If you are using Fusion 360, check out my CNC12 specific Post Processor
If you are using a Touch Probe, Tool Touch Off Device or a Triple Corner Finder Plate, check out my ProbeApp

Contact me at swissi2000@gmail.com
cnckeith
Posts: 2931
Joined: Wed Mar 03, 2010 4:23 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: Yes
Oak CNC controller: Yes
MPU11 & GPIO4D -w/ 3rd Party Drives: Yes
DC3IOB: Yes
CNC11: Yes
CPU10 or CPU7: Yes
CNC Control System Serial Number: none
Contact:

Re: KP-3 Probe

Post by cnckeith »

please refer to the KP- 3 manual, download the latest version here.

https://www.centroidcnc.com/centroid_di ... _probe.pdf
When requesting support READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043

Please ALWAYS post a FRESH report. To make a report: https://www.youtube.com/watch?v=Ecvg0VJp1oQ.

(We pride ourselves on providing timely solid technical support but, without good information we may not be able to help and/or reply until such information is posted.)
Post Reply