Today we were running job on a mill (Centroid, All in one DC) and feed hold (we don't have a pendant, so use space bar on keyboard) would not respond. Right above the task window we could see FEED HOLD highlighted with red. The job was running fine, though. Is it a known issue? Is there any other way to stop in the middle of the job?
Thanks, Mark
Feed Hold not responding
Moderator: cnckeith
-
Marik
- Posts: 65
- Joined: Sun Dec 08, 2013 1:42 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
Feed Hold not responding
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
diycncscott
Re: Feed Hold not responding
Marik,
When requesting support, please always post a current report.zip from your system or email it to tech@ajaxcnc.com
We haven't seen this issue on other systems and without a report we can't determine what the cause might be.
When requesting support, please always post a current report.zip from your system or email it to tech@ajaxcnc.com
We haven't seen this issue on other systems and without a report we can't determine what the cause might be.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)