Feed rate override question

Mrcadcam · Post by **Mrcadcam** » Fri Dec 20, 2019 3:35 pm

I'm new to centroid controls and I have a CNC11 DC system. I recently just powered it up and noticed that the feed rate override knob turns past 100% but the readout on the screen will not go beyond 100%. It will go less than 100% down to 2% but not over. Is this normal? Thanks for helping out a centroid newbie.

tblough · Post by **tblough** » Fri Dec 20, 2019 5:26 pm

Parameter 39 controls the feedrate override limit. It can be set up to 200 to allow 200% of the programmed feedrate.

Mrcadcam · Post by **Mrcadcam** » Mon Dec 23, 2019 5:59 pm

Thanks I checked it and it's set on 100 unfortunately I can't change it because it is password protected and I did not receive a password on purchase and cannot query the previous owner for it.....so I'm kind of stuck. Is there a way around the password?

Mrcadcam · Post by **Mrcadcam** » Mon Dec 23, 2019 6:09 pm

Never mind I looked in the forum and saw that 137 is used for a password so I tried it and it let me in. Then I was able to change parameter 39 to 200

Centroid Community CNC Support Forum

Feed rate override question

Feed rate override question

Re: Feed rate override question

Re: Feed rate override question

Re: Feed rate override question