Autotune
Moderator: cnckeith
-
warnerr
- Posts: 21
- Joined: Fri Jun 14, 2019 10:10 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: a900749
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Autotune
My mill is limited to 3.60 in Z- not enough for autotune. Is it possible to edit the file to tune Z in a shorter area or must I go manual tune? Allinonedc system.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
Re: Autotune
See the manual for Machine Parameters 95-98 (in this case, P97).
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
warnerr
- Posts: 21
- Joined: Fri Jun 14, 2019 10:10 pm
- Acorn CNC Controller: No
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: a900749
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Autotune
Thanks! will read up
... That is easy! just a note: the support here is fantastic! Not used to it as i am coming from the IT world where finger pointing to the other guy is the usual answer. lol. Thanks again!
... That is easy! just a note: the support here is fantastic! Not used to it as i am coming from the IT world where finger pointing to the other guy is the usual answer. lol. Thanks again!(Note: Liking will "up vote" a post in the search results helping others find good information faster)