Hello ,
We have a serious problem with gsk servo driver , first for activating the enable of servo driver with GPIO4D board we need at least 12 v and the board give only 5v and if we activate the enable on the servo driver we have feedback from encoder without motion it is very difficult so we have think about activating the enable with relay situated on the GPIO4D board and we don't know how we will do that please we need urgent help for and thank you very much.
GSK servo driver with GPIO4D
Moderator: cnckeith
-
cheker1988
- Posts: 1
- Joined: Sun Dec 16, 2012 2:01 pm
- Allin1DC CNC Controller: No
- CNC Control System Serial Number: forget it
- DC3IOB: No
- CNC11: Yes
- CPU10 or CPU7: No
GSK servo driver with GPIO4D
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
CNC-Global
- Posts: 56
- Joined: Fri Jun 10, 2011 8:40 am
- Allin1DC CNC Controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
Re: GSK servo driver with GPIO4D
Gsk driver do not accept analouge input it works only in position mode.
Aamir
Aamir
(Note: Liking will "up vote" a post in the search results helping others find good information faster)