V 4.18 probing
Moderator: cnckeith
-
Dholman
- Posts: 52
- Joined: Mon Aug 06, 2018 11:44 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
Re: V 4.18 probing
I'm stupid didn't look at my wirring diagram done a fresh install missed input 7 thanks
Last edited by Dholman on Wed May 22, 2019 12:30 am, edited 2 times in total.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
Dholman
- Posts: 52
- Joined: Mon Aug 06, 2018 11:44 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
Re: V 4.18 probing
What is bad is I had probe tripped wrote on my wirring diagram just shows too double check before opening your dumb mouth
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
martyscncgarage
- Community Expert
- Posts: 9953
- Joined: Tue Mar 28, 2017 12:01 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Location: Mesa, AZ
Re: V 4.18 probing
Glad you got it going. There is a link to the probing documentation in the Probing section of the Wizard.
Thanks Swissi for the help!
Marty
Thanks Swissi for the help!
Marty
Reminder, for support please follow this post: viewtopic.php?f=20&t=383
We can't "SEE" what you see...
Mesa, AZ
We can't "SEE" what you see...
Mesa, AZ
(Note: Liking will "up vote" a post in the search results helping others find good information faster)