Run Time Graphics

[danny]

Hello !
Im Just doing the last finishing touches on my mazak lathe retrofit with oak board and i ran a small program to test the machine .
All looks great but the run time graphics come up as they should but its not showing the Trail , i tried F9 on and off but no change !!
Any ideas anyone ?

Thanks

[cnckeith]

zero tool diameter?

[wellington_tregear]

Old thread, I know. But for future readers, here is additional info.

I too had this problem of no trail being shown (but it did show recently, before a centroid software update). Keith's comment made me realize that I did not have a tool specified at all in the gcode. It was hastily written test code and no tool was called out. Simply adding "t1" in the code made trail show (which does have a dia in the tool table).