Gecko 203v/214v wiring question/NEW ROUTER BUILD

[Dan M]

Well the heavy lifting is done now time for all the electronics.

[Dan M]

Did a little test fitting yesterday.

[Dan M]

Got the MDF cut up today. Getting closer every day.

[martyscncgarage]

Cool. Looking forward to seeing the control installed on it, and it running.

[Dan M]

Cool. Looking forward to seeing the control installed on it, and it running.

Me too. I’m just waiting on my Automation Direct order and for some incorrect parts to be replaced from the table manufacturer. I’m hopeful that everything is here by next week so I can start testing the machine. I’m also keeping my fingers crossed that all goes well with the controller, the configuration is daunting since I’ve never done it before. Hopefully the configuration wizard is relatively simple once I actually start using it. Is it very difficult to set up the motors, sensors and spindle? As I said this is all new to me and I appreciate your help.

Thanks,
Dan

[martyscncgarage]

Did you want the videos in the ACORN CNC VIDEOS Forum?
Lots of good info and help there to get you started.

viewforum.php?f=61

Marty

[Dan M]

Did you want the videos in the ACORN CNC VIDEOS Forum?
Lots of good info and help there to get you started.

viewforum.php?f=61

Marty

Yes I’ve watched and read everything. And once everything is wired up and ready to setup with the wizard, I will watch the appropriate ones again along with read the manual. I just haven’t messed with anything and don’t know what to expect. I’m hopeful that everything is straight forward. I’ll let you know how it goes next week when the controller is finished.

Thanks again Marty,
Dan

[Dan M]

Spaghetti time.

[Dan M]

Some more pics.

[martyscncgarage]

I see some cabling and motors mounted....