Need Help

[martyscncgarage]

No, these are not genuine Leadshine drivers but they use the same manual as the real Leadshine. Yes, the motors are locked when the control is turned on which, uses the 5V power to the drivers. I also disconnected the "Enable" wire from the Acorn. I got the db25 BOB and used that but still, the motors won't turn. I really appreciate all of the help that you are providing. But to be honest this is really becoming very frustrating. Is there anything else that I can try.

Did you INVERT the step and direction signals in Wizard? Leadshine requires that.
Your screen shot only shows the Enables inverted on Axis 1 & 2
Did you try that?

I believe they should work just fine on the Acorn Step/Dir terminals.

[DICKEYBIRD]

I'll look at my settings when I get home from work & get back to you. Maybe we'll find something. I'm sure it's a minor setting somewhere.

[twoody65]

I wanted to say Thank you guys for all of your help trying to get these drivers to work. But I just went ahead and bought a Gecko G540. Once again thank you.

[martyscncgarage]

I wanted to say Thank you guys for all of your help trying to get these drivers to work. But I just went ahead and bought a Gecko G540. Once again thank you.

You'll be happy with the G540 as an open loop drive.
Check your PMs...
Marty

[fjrodriguez]

Hi,

I am running it with DM542T and two generic (OEM) motors 425 Oz-pul. It wire exactly as the Leadshine diagram. It works after switch db to "screw terminal" on the CNC wizard tab.

[martyscncgarage]

Hi,

I am running it with DM542T and two generic (OEM) motors 425 Oz-pul. It wire exactly as the Leadshine diagram. It works after switch db to "screw terminal" on the CNC wizard tab.

Cool, so you are up and moving motors?

[fjrodriguez]

Yes, it works correctly.

[martyscncgarage]

[martyscncgarage]

Check your private messages...
Marty