Been using the Acorn with clearpath servos all working well, the only issue I have is that I can't get the Z axis to rapid move.
In the wizard the maximum speed seems set to 150, is this correct? I am engraving 800 parts and the z axis speed is slowing the cycle down. Can the Z axis speed be increased?
Thanks.
Acorn Z axis feed rate too slow
Moderator: cnckeith
-
paulepc
- Posts: 10
- Joined: Sat Dec 16, 2017 9:52 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: (9884E398B8B31130170293)
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
Acorn Z axis feed rate too slow
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
cnckeith
- Site Admin
- Posts: 8942
- Joined: Wed Mar 03, 2010 4:23 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Contact:
Re: Acorn Z axis feed rate too slow
Need support? READ THIS POST first. http://centroidcncforum.com/viewtopic.php?f=60&t=1043
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
All Acorn Documentation is located here: viewtopic.php?f=60&t=3397
Answers to common questions: viewforum.php?f=63
and here viewforum.php?f=61
Gear we use but don't sell. https://www.centroidcnc.com/centroid_di ... _gear.html
(Note: Liking will "up vote" a post in the search results helping others find good information faster)