I line up a few simple parts and the fist one cuts great at 34 imp on 3/8 steel same with the second hole but then for some reason the next cut shifts down the speed almost to 2 ipm also my jog speed is so low its worthless. Now I havent touched anything when this happens just does it automatically.
The only way I know of right now to get my jog speed and my cut speed back is to close out and power cycle the board. Kind of worried because this is the 5 time its happened since cutting. Im stuck in the middle of a job because I dont know how to start the job in the middle, I can start over again and just waste some steel I guess.
Somethings going wrong with cut speed.
-
AWFAB
- Posts: 9
- Joined: Wed Feb 28, 2024 12:49 am
- Acorn CNC Controller: No
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Somethings going wrong with cut speed.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
Joey
- Plasma/Laser Lead
- Posts: 660
- Joined: Tue Aug 17, 2021 10:51 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Somethings going wrong with cut speed.
Please Post a Fresh Report and the G-code please.
Is the Feed rate Override at %100 percent on the VCP?
Are you running the CNC12 version 5.3 software? If not I would update to the latest rev for sure.
Here is a walk through video of the Latest 5.3 version of restart mode.
Is the Feed rate Override at %100 percent on the VCP?
Are you running the CNC12 version 5.3 software? If not I would update to the latest rev for sure.
Here is a walk through video of the Latest 5.3 version of restart mode.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)