USB-bob on Oak

[theMTa4]

Hello,

I recently bought a USB-Bob for my oak
I installed it this weekend but I was not able to have it worked. I need help for PLC.

I already put this in the plc but after i don't understand where integrate ExtUsbFeedKnob_W for exemple.

Code: Select all

;FeedKnobs (32bit Word)
ExtUsbFeedKnob_W IS SV_PC_EXT_USB_PANEL_W_1 
ExtUsbSpinKnob_W IS SV_PC_EXT_USB_PANEL_W_2
ExtUsbRapidKnob_W IS SV_PC_EXT_USB_PANEL_W_3
;FeedKnobs for second USBBOB (32bit Word)
ExtUsbKnob4_W IS SV_PC_EXT_USB_PANEL_W_4
ExtUsbKnob5_W IS SV_PC_EXT_USB_PANEL_W_5
ExtUsbKnob6_W IS SV_PC_EXT_USB_PANEL_W_6

Hardware side , H7 is my spin knob , H6 feedknob , H8 X mpg , H9 Y mpg , H10 Zmpg.

used: centroid 5.30 and last plc ( Centroid_OAK_Mill_Standard-r11 )
configured parameter 496 to COM port of USB-bob detected.

Thanks for help.
Kind Regards , Jerome.

[gttool]

Need some help with integration to an Allin1DC also