Hello, Noob here, and possibly dumping M4 to go to Acorn.
in the CNC-12 programming,
Is it possible to have an input switch directly drive one (or 2) of the output relays directly?
Can one input drive 2 relays at the same time? (if i needed a DPDT, using 2 of the SPDT relays)
Same as if it was a toggle switch directly wired to the coil of a relay?
Thank you for the help and input.
Input directly controls an output relay <Answered>
Moderator: cnckeith
-
imacav8r
- Posts: 1
- Joined: Wed May 28, 2025 9:50 am
- Acorn CNC Controller: No
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Input directly controls an output relay <Answered>
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
suntravel
- Community Expert
- Posts: 3525
- Joined: Thu Sep 23, 2021 3:49 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 6433DB0446C1-08115074
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Germany
Re: Input directly controls an output relay
Sure, no problem
Uwe
Uwe
(Note: Liking will "up vote" a post in the search results helping others find good information faster)