Can you move the line by line cycling thru the gcode? < single block mode>

[Rare]

Hello
Is there a way to move the machine line by line of the gcode?
lets say your gcode has 4 lines of movement...is there a way move the machine at line1 then line2 etc?
hopefully with the spindle off.

why ...lets say I drilled a hole and messed up by deleting the zero position. I re-zero
and I want to recheck slowly if the program will cut in the same place...with out needing to run the whole program.

Thank you!

[suntravel]

Sure

F4 Run Job Options / F5 Single Block Mode

Uwe