Will SystemStatus be ready soon? <resolved>
Moderator: cnckeith
-
robtown
- Posts: 124
- Joined: Mon Oct 15, 2018 10:13 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: F045DA78F172-1129181385
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
- Location: Atlanta GA
Will SystemStatus be ready soon? <resolved>
Is the SystemStatus control still being developed for release? Something I’m interested in exploring goes on in there, or I may be able to use the SystemState control.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
Centroid_Jacob
- Posts: 82
- Joined: Wed Oct 19, 2022 4:49 pm
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: No
- CNC11: Yes
- CPU10 or CPU7: No
Re: Will SystemStatus be ready soon?
Hi robtown,
I'm not sure what you mean by SystemStatus control, maybe this is something that was mentioned before my time here at CentroidCNC.
We do have some example controls available for the CentroidAPI, for use with the WPF Project Type.
I don't see any references to SystemStatus, however.
Could you provide more information about your goals for using a SystemStatus or SystemState control?
I'm not sure what you mean by SystemStatus control, maybe this is something that was mentioned before my time here at CentroidCNC.
We do have some example controls available for the CentroidAPI, for use with the WPF Project Type.
Could you provide more information about your goals for using a SystemStatus or SystemState control?
When requesting support please read this post first.
A fresh report makes it easier to assist you. To make a report check this post
A fresh report makes it easier to assist you. To make a report check this post
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
robtown
- Posts: 124
- Joined: Mon Oct 15, 2018 10:13 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: F045DA78F172-1129181385
- DC3IOB: No
- CNC11: No
- CPU10 or CPU7: No
- Location: Atlanta GA
Re: Will SystemStatus be ready soon?
Sorry, I was reading something else and got crossed up.
StatusWindow and MessageWindow seem to be what I'm looking for.
StatusWindow and MessageWindow seem to be what I'm looking for.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)