Centroid Community CNC Support Forum

Posted: **Thu Dec 14, 2023 7:49 pm**

CNC12 v5.08 for Hickory is now available as a release candidate.

https://centroidcncforum.com/viewtopic.php?f=67&t=9517

all Hickory users should update to this version as there are numerous Hickory related improvements in this version.

Posted: **Sat Feb 24, 2024 5:44 pm**

I don't know what's happened but after installation CNC12 v5.8 I can't see VCP.
How I could swich on VCP.
Can somebody help me?
report was attached.

Posted: **Sat Feb 24, 2024 8:11 pm**

Set Parameter 219 = 1.

Posted: **Sun Feb 25, 2024 4:00 am**

cncsnw wrote: ↑Sat Feb 24, 2024 8:11 pm Set Parameter 219 = 1.

Thank you

Centroid Community CNC Support Forum

CNC12 v5.08 for Hickory is now available as a release candidate.

CNC12 v5.08 for Hickory is now available as a release candidate.

Re: CNC12 v5.08 for Hickory is now available as a release candidate.

Re: CNC12 v5.08 for Hickory is now available as a release candidate.

Re: CNC12 v5.08 for Hickory is now available as a release candidate.