I know centroid has ordered an ethercat card for the Delta C2000 and MS300 VFD's to allow it to be hooked up to ethercat and eliminate all those pesky wires. Could you let us fine folks know how that is progressing?
I hope to be able to test it on my delta C2000 in about 2 weeks. Thanks
Delta C2000 / MS300 Ethercat implementation
Moderator: cnckeith
-
spikee
- Posts: 76
- Joined: Thu Feb 01, 2024 5:34 am
- Acorn CNC Controller: No
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Contact:
Delta C2000 / MS300 Ethercat implementation
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
eng199
- Posts: 415
- Joined: Fri Jan 10, 2014 11:29 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: none
- DC3IOB: Yes
- CNC12: Yes
- CNC11: Yes
- CPU10 or CPU7: Yes
- Location: Howard, PA
Re: Delta C2000 / MS300 Ethercat implementation
That feature will not be ready in 2 weeks.
(Note: Liking will "up vote" a post in the search results helping others find good information faster)
-
spikee
- Posts: 76
- Joined: Thu Feb 01, 2024 5:34 am
- Acorn CNC Controller: No
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Contact:
Re: Delta C2000 / MS300 Ethercat implementation
Thanks for that, could you give perhaps indicate a rough timeline of how long it would take?
(Note: Liking will "up vote" a post in the search results helping others find good information faster)