You could submit a software change request to Centroid, suggesting that if "G code preview" is enabled with P417, and the last job ran to a successful completion, then the CNC12 main screen display should (perhaps after a short delay) revert to displaying the preview of the top of the job, instead of continuing to show the last lines that were running.
Software feature request: M30 rewind
Moderator: cnckeith
-
Houseman303
- Posts: 106
- Joined: Sun Nov 12, 2023 1:33 pm
- Acorn CNC Controller: No
- Plasma CNC Controller: No
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: Yes
- CNC Control System Serial Number: A901313
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Switzerland