CNC12 v5.0+ Draft Operator's Manual Mill/Lathe

[cncjenna]

After testing V5.04 on my lathe and a short conversation with Keith and Chris, Paramater 458 is missing in the Lathe Manual.

Must be set to 1 to keep C-Axis on outside a job for manual jogging and display on the DRO.

Uwe

Thanks Uwe, Chris let me know about this and it has been fixed on our end.

[cncjenna]

Reading the new manual....

Boo-boo on page 51. The F button descriptions do not correlate to the screen example.
Actually the F1 is correct but then the rest of the button descriptions are off by 2...ie F2 is really F4, F3 is F5 etc.

Thank you for pointing this out! It has been fixed on our end and the corrections will be seen with the next draft release.