Slow Jogging

Moderator: cnckeith

Post Reply
Toaster
Posts: 195
Joined: Mon Oct 29, 2018 5:25 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: none
DC3IOB: No
CNC11: No
CPU10 or CPU7: No

Slow Jogging

Post by Toaster »

I'm seeing slow jogging on this version...

When using the jog buttons on the VCP positive moves work at full speed, but negative moves on XYZ seem to go at half speed... Is this a new setting I'm not aware of?

Report attached.
Sword
Posts: 651
Joined: Fri Nov 30, 2018 1:04 pm
Acorn CNC Controller: Yes
Plasma CNC Controller: No
AcornSix CNC Controller: No
Allin1DC CNC Controller: No
Hickory CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: none
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No
Location: Thorp WI

Re: Slow Jogging

Post by Sword »

Check the axis config in the wizard or setup/config/machine/jog. There's a new separate fast jog +/- setting.
Scott
Toaster
Posts: 195
Joined: Mon Oct 29, 2018 5:25 pm
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: none
DC3IOB: No
CNC11: No
CPU10 or CPU7: No

Re: Slow Jogging

Post by Toaster »

There sure is! I missed that one!

One thing I did notice is that with the pendant it jogs fast in all directions.. I like that just fine but it might be worth noting that the VCP and pendant jog behavior is different.
Post Reply