How to use g-code smoothing with a lathe
Posted: Sun May 21, 2023 12:52 pm
If you program feed/min instead of feed/revolution, it is possible to use smoothing on a lathe also for turning.
Also good to use for mill-turn with C-Axis and small vector files for a smooth surface.
At the moment lathe will not feature smoothing from the UI or G64 to turn it on, but with setting the parameters it works fine.
Uwe
Also good to use for mill-turn with C-Axis and small vector files for a smooth surface.
At the moment lathe will not feature smoothing from the UI or G64 to turn it on, but with setting the parameters it works fine.
Uwe