WMPG failure to connect to MpgClient.exe
Posted: Mon Nov 28, 2022 7:11 pm
This is not a machining/programming topic, but I am posting it here because it applies equally to Acorn and to closed-loop controls.
On a couple recent systems, I have encountered intermittent failure of the wireless MPG to communicate with CNC12. The WMPG display shows a good signal and plenty of battery, but the MpgClient.exe software apparently does not detect it. The DRO display does not appear on the wireless MPG, and CNC12 responds to neither the handwheel nor the keys.
In at least one case, a warning message was displayed on startup indicating that a wireless MPG was configured, but not detected. Interestingly, I do not recall ever having gotten that message when the WMPG was present but turned off.
Has anyone else encountered this situation?
On a couple recent systems, I have encountered intermittent failure of the wireless MPG to communicate with CNC12. The WMPG display shows a good signal and plenty of battery, but the MpgClient.exe software apparently does not detect it. The DRO display does not appear on the wireless MPG, and CNC12 responds to neither the handwheel nor the keys.
In at least one case, a warning message was displayed on startup indicating that a wireless MPG was configured, but not detected. Interestingly, I do not recall ever having gotten that message when the WMPG was present but turned off.
Has anyone else encountered this situation?