Like most hobbyist, I have a smaller lathe with a 6" chuck. When I've got soft jaws mounted, I'm always searching for something to clamp down on to bore the jaws. I have looked at setting rings; Eagle Rock seems to make the most common set of 48 rings from 1" to 3-15/16" by 1/16" for around $350. On my 6" chuck with a minimum of two scroll threads in the jaws, my largest diameter is only 3" on the master jaws.
So, the largest rings in the Eagle Rock set would be wasted. Instead of the full 48 ring set from Eagle Rock, you can also buy a smaller 16 piece set that goes from 1" to 1-15/16" that would be a better fit for 4", 5" and 6" lathe chucks. However it's still around $150.
I was doing some motor work with a friend today and he had a set of Snap-On bushing drivers. To me, they looked like setting rings. Problem was the Snap-on name cost you dearly. A quick search on eBay turned up these:
52 "setting rings" from 0.7" to 2.6" by 0.04" and a 2.9" ring as well. All of these rings for $50! It even includes a little handle to help you hold the rings towards the back of the master jaws while closing down on it. And, the 3/64" increments will make the soft jaws last a little longer.
Search for "52 bushing driver set" on eBay and choose from the hundreds of vendors selling these.
Cheap setting rings for turning soft jaws
Moderator: cnckeith
-
- Posts: 3151
- Joined: Tue Mar 22, 2016 10:03 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: Yes
- Oak CNC controller: Yes
- CNC Control System Serial Number: 100505
100327
102696
103432
7804732B977B-0624192192 - DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
- Location: Boston, MA
- Contact:
Cheap setting rings for turning soft jaws
Cheers,
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
Tom
Confidence is the feeling you have before you fully understand the situation.
I have CDO. It's like OCD, but the letters are where they should be.
-
- Posts: 112
- Joined: Fri Apr 13, 2018 10:04 am
- Acorn CNC Controller: No
- Allin1DC CNC Controller: Yes
- Oak CNC controller: No
- CNC Control System Serial Number: 101981
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Cheap setting rings for turning soft jaws
We need a like button.
Dave Koehler
https://www.koehlerinjection.com
https://www.koehlerinjection.com