Torch Height and Amperage

[Joey]

Joey, Thanks for the help. And patience.

I Will redo the Torch calibration,

To confirm from the posts,I can gather from your replies and help that the Plots look good, and the grounding issues are fixed and I'm good to do further cutting without damage?

The Dry run plots would of shown the interference from a ground loop.
I was just hesitant to do any cutting until the dry run plots stopped showing interference.
I'd say your clear to start cutting

Thanks again, it is appreciated.
No problem glad to see this resolved

[Joey]

I've Created a short walkthrough video of the 4inch line plot.

https://photos.app.goo.gl/8JZ3ZBamVvZSxFRr8