Kinda new to this! Need a little help getting my plasma to work with acorn and thc
-
- Posts: 1
- Joined: Mon Jan 15, 2024 9:42 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: Yes
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: E06234795237-0422225978
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Kinda new to this! Need a little help getting my plasma to work with acorn and thc
I'm having issues with basic stuff like, I don't know what to hoop up the trigger wires from my plasma to the hardware on the thc controller. And I don't understand the thc as far as it sensing height and the best way to configure it. Could anyone help with basic dummy problems? Haha TIA!
-
- Posts: 521
- Joined: Tue Aug 17, 2021 10:51 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Kinda new to this! Need a little help getting my plasma to work with acorn and thc
Can you start a Google photo album?
You can then share a link in the post. If you upload pictures of your plasma cutter, the CNC port on the back with the pins you can certainly help you get it hooked up.
It's a lot easier with pictures to see what you're working with.
Just throw up as many as you can.
What plasma cutter do you have? What does your table look like and cabinet?
Have you found the schematics yet?
Search Plasma on the schematics look up page to see plasma schematics
https://www.centroidcnc.com/centroid_di ... browse.php
plasma installation manual is here.
https://www.centroidcnc.com/centroid_di ... manual.pdf
You can then share a link in the post. If you upload pictures of your plasma cutter, the CNC port on the back with the pins you can certainly help you get it hooked up.
It's a lot easier with pictures to see what you're working with.
Just throw up as many as you can.
What plasma cutter do you have? What does your table look like and cabinet?
Have you found the schematics yet?
Search Plasma on the schematics look up page to see plasma schematics
https://www.centroidcnc.com/centroid_di ... browse.php
plasma installation manual is here.
https://www.centroidcnc.com/centroid_di ... manual.pdf