Torch sensor hookup
-
_Duke_
- Posts: 20
- Joined: Mon Dec 04, 2023 4:44 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: Yes
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 0035FF8A4D57-0713203500
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Torch sensor hookup
I don't think you'll be able to diagnose much from more photos of the cabinet- it's kind of a disaster right now. A lot of the wiring is temporary until I'm sure everything works, and until I can find a larger cabinet. But I added some to the album
-
Joey
- Posts: 516
- Joined: Tue Aug 17, 2021 10:51 am
- Acorn CNC Controller: Yes
- Allin1DC CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: none
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Torch sensor hookup
Had to look at the pictures again with a fresh mind set.
Eureka I found it!
Float and breakaway should be on output 1 and 2 of the RX not input 1 and 2 of the RX
Thanks for the Pictures! That made the difference
Eureka I found it!
Thanks for the Pictures! That made the difference
-
_Duke_
- Posts: 20
- Joined: Mon Dec 04, 2023 4:44 pm
- Acorn CNC Controller: Yes
- Plasma CNC Controller: Yes
- AcornSix CNC Controller: No
- Allin1DC CNC Controller: No
- Hickory CNC Controller: No
- Oak CNC controller: No
- CNC Control System Serial Number: 0035FF8A4D57-0713203500
- DC3IOB: No
- CNC12: Yes
- CNC11: No
- CPU10 or CPU7: No
Re: Torch sensor hookup
Joey you're my hero!
I knew I'd feel like an idiot before this was over, so glad you were able to see through my sloppy wiring and spot the problem!
Eureka indeed!
I knew I'd feel like an idiot before this was over, so glad you were able to see through my sloppy wiring and spot the problem!
Eureka indeed!