Page 1 of 1
thc encoder error
Posted: Mon Nov 27, 2023 4:21 pm
by jeffery.meacham
we have cut several parts this morning with ease we are getting a 9105 encoder error both tx and rx boards are getting power fiberoptic cable appeares to be fine any ideas?
Re: thc encoder error
Posted: Mon Nov 27, 2023 6:10 pm
by Joey
Can you attach a fresh report.
Is the encoder error intermittent?
A loose encoder cable could also cause an encoder error.
Re: thc encoder error
Posted: Tue Nov 28, 2023 9:17 am
by jeffery.meacham
attached is a current report any ideas would be helpful after trying different things i noticed when we disable thc machine will move again and operate normally yet no thc enable thc and 9105 encoder error prevents everything from moving
Re: thc encoder error
Posted: Wed Nov 29, 2023 2:29 pm
by Joey
Looking through the Plots in the report I'm not seeing any voltages read in any plots.
Did you do a calibration cut?
Do you know the THC was ever working?
What Plasma cutter do you have?