Acorn + PlasmaSens THC+ Everlast82i hookup
Posted: Sat Mar 18, 2023 4:30 am
Hey guys , this is my third time working with Acorn and Clearpath servos, this time our shop already built 9x5 ft plasma table , we wanted to save up some $ a bit with the controller at first and went with PlanetCNC which turns out to be a complete garbage, so back to good old Acorn, now we already purchased a Polabs PlasmaSense THC https://planet-cnc.com/product/plasma-t ... ontroller/ , good thing about it is I can either pull divided or raw voltage from CNC port on Everlast 82i directly into sensor end which is also using 110V for logic, optically isolated etc , the question is how would I make it work with Acorn? Plasmasens Controller end doesn't have serial port out , it has 4 Output signals: Arc Ok, Up and Down and common (normally-open solid-state relay outputs) and 6-36VDC for logic, which would work perfect with Acorn power supplies , my question is if I connect Arc OK, Up and Down into Acorn Inputs, are they programmable to act as THC Z-axis control in CNC12 Plasma ? If not, what other solution would you recommend?
Ps I currently don't have CNC12 Plasma license to try it out , looking for solutions
Thank you!
Ps I currently don't have CNC12 Plasma license to try it out , looking for solutions
Thank you!