Acorn CNC Plasma/Everlast82i

All things related to the Centroid Acorn Plasma system.

Moderators: cnckeith, Joey

Post Reply
wbhall38
Posts: 5
Joined: Thu Dec 17, 2020 11:23 am
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: none
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No

Acorn CNC Plasma/Everlast82i

Post by wbhall38 »

Greetings,
Does anyone have any information on setting up a everlast 82i plasma cutter with the acorn thc board?

Best Regards,

Walter Hall
Joey
Posts: 465
Joined: Tue Aug 17, 2021 10:51 am
Acorn CNC Controller: Yes
Allin1DC CNC Controller: No
Oak CNC controller: No
CNC Control System Serial Number: none
DC3IOB: No
CNC12: Yes
CNC11: No
CPU10 or CPU7: No

Re: Acorn CNC Plasma/Everlast82i

Post by Joey »

BMF has a thread where he was trying tlan Everlast with the THC. The THC plots didn't look too bad just that I'm not sure if the calibration was able to use the voltage. Looked like THC did react to the spike at the end of the cut. Not sure if his target voltage was just not set right. He was going to post another report when he had more parts to make. His thread is here.

https://centroidcncforum.com/viewtopic. ... ast#p69748


I'll ask if he has cut anything else yet.
Post Reply