Re: Tru Cut A80 Thermal Dynamics Will It Work?
Posted: Wed Feb 01, 2023 1:49 am
I have all of the Acorn boards installed and mostly wired in, but I've hit a wall on the thc board wiring.
I have six wires coming from my plasma cutter.
Green OK
White OK
Red V+
Black Common
Blue Start
Yellow Stop
I've looked at several different diagrams and can't seem to figure out a good idea. What exactly is ok to move and how does the cutter get the signal from Acorn?
There are three options for Divided Arc Voltagesignal supplied from the automation interface PCB.This is selected by connecting the black Jumper Plug on the P1 connector as follows:Arc voltage / 16.67 Jumper not installedArc voltage / 30 Jumper Pins 1 & 2 . This is the factorydefault position of the jumperArc voltage / 50 Jumper Pins 2 & 3rn.
I copied what looks to be the divided voltage settings. Correct me if I read it wrong but it looks like the lowest setting is 16v.
If this is the case it looks like my cutter will not work with this THC.
I have six wires coming from my plasma cutter.
Green OK
White OK
Red V+
Black Common
Blue Start
Yellow Stop
I've looked at several different diagrams and can't seem to figure out a good idea. What exactly is ok to move and how does the cutter get the signal from Acorn?
There are three options for Divided Arc Voltagesignal supplied from the automation interface PCB.This is selected by connecting the black Jumper Plug on the P1 connector as follows:Arc voltage / 16.67 Jumper not installedArc voltage / 30 Jumper Pins 1 & 2 . This is the factorydefault position of the jumperArc voltage / 50 Jumper Pins 2 & 3rn.
I copied what looks to be the divided voltage settings. Correct me if I read it wrong but it looks like the lowest setting is 16v.
If this is the case it looks like my cutter will not work with this THC.